Variable load spring supports are used for supporting pipe work, vessels, columns and pipe connections to large tanks, that are subject to thermal movement and/or subsidence.
They are used when it is not possible to use rigid hangers and Constant load spring supports would be uneconomical.
This full travel may be used providing the necessary calculations are carried out to ensure that the pipe work and nozzle connections can withstand the large changes that occur during pipe movement.
Most international standards advise a maximum load variation of 25%, it is therefore recommended to select a variable effort spring support on this basis. Care should always be taken to ensure that the selected unit has sufficient travel available to permit the free vertical movement of the pipe when moving from the cold to hot position.
Binder recommends that pipe load is correctly supported when the pipe is in its normal working position. This ensures that no abnormal or excessive forces is transferred to the pipe work in its stressed working condition due to out of balance supporting effort.
The Binder Group manufactures four basic travel range units. These are BV35, BV70, BV140 and BV210 and have a maximum working range of 35mm, 70mm, 140mm and 210mm respectively.
|Nama Produk||:||VARIABLE LOAD SPRING SUPPORTS|
|Minimal Jumlah Pesan||:||Data Belum Tersedia|
|Harga||:||Data Belum Tersedia|
|Syarat Pembayaran||:||Data Belum Tersedia|
|Kemampuan Pasokan||:||Data Belum Tersedia|
|Rincian Kemasan||:||Data Belum Tersedia|
|Waktu Pengiriman||:||Data Belum Tersedia|
Harga Tidak Tersedia